Installation

Zip Hinge™ Installation Instructions

Tools Required: Tin Snips, 1/4” Hex Bit and a Drill

instructions01Using tin snips, cut out a 45 degree angled section of the downspout extension.
 
 
 
 
 
 
instructions02Slide the Zip Hinge™ onto the elbow of the downspout and secure with zip screws. Make sure the Zip Hinge™ is fully seated before attaching.
 
 
 
 
 
instructions03Slide the cut section of the downspout extension into the Zip Hinges™ and secure with zip screws. Make sure the downspout is fully seated before attaching.
 
 
 
 
 
 

Optional Zip Hinge™ Clasp Installation Instructions

Tools Required:1/4” Hex Bit, Drill

instructions04Bend clasp at notches to approximately 20 degrees.
 
 
 
 
 
 
 
instructions05Use zip screw to attach clasp 3/4 inches above raised extension.
 
 
 
 
 
 
instructions06Rotate clasp to vertical position to hold extension upright.